Regulator Accessories

OTG Scuba Diving Female 3/8"-24 to Male 1/4" NPT Adapter is for divers to change the first stage end of a regulator hose to 1/4" NPT male threads. This adapter is made by marine chrome plated brass. The working pressure is below 200psi and is for low pressure use only.

OTG Tech Scuba Diving 316 Stainless Steel 70mm(L) Swivel Eye Bolt Snap is commonly used with regulators, smaller back-up lights or any accessories that being attached to a BC or harness for stowing. Use this one to setup your long hose primary second stage.

All of our Premium Stainless Steel snaps are made by heavy-duty 316 stainless steel alloy which suitable for marine applications. For long life and ease-of-use, the interior spring is also made of stainless steel alloy. Tips for storage: Please rinse your bolt snap in fresh water after each dive.

OTG Scuba Diving Second Stage Regulator to Scubapro BC Inflator Hose Quick Disconnect Adapter allows you to turn your second stage regulator into a quick disconnect device. Nowadays it is commonly to use with second stage or full face mask system. Just simply install the female end to any standard second stage regulator with 9/16"-18 UNF threads. And the nipple end is fit to connect to Scubapro BC quick disconnect adapter. This adapter is made by Marine Chrome Plated Brass and is completed 40% Nitrox ready. The working pressure is below 200psi and is for low pressure use only.

OTG Scuba Diving First Stage Regulator Yoke Large Nuts Removal Service Tool is used for the removal and installation of the yoke large nuts on the first stage regulator. This service tool is fit for most common size yoke large nuts including 19mm, 21mm, 25.4mm and 26mm (diameter of yoke large nuts). The material of the tool is heavy duty 7075 aluminum alloy. It is lightweight but durable.

OTG Scuba Diving First Stage Regulator Holder Handle Bar has both 3/8"-24 and 7/16"-20 male threaded end to allow threading into the LP or HP ports of the first stage regulator body. It is much more easy and stable to hold your first stage while servicing.

OTG Scuba Diving First Stage Regulator Cup Pin Spanner Wrench Service Tool is commonly used for the removal and installation of the high pressure seat retainer on the first stage regulator. This cup wrench tool is adjustable and the adjust range is up to 58mm between pin to pin. The pin size of this tool is 2.75mm and the total length of the tool is approx. 6.25 inches.

OTG Technical Scuba Diving Bungee Regulator Necklace is an idea for technical divers to keep the back up regulator stowed under the chin for instant availability. The opening of the necklace is simply pushed over the second stage regulator mouthpiece, and even over the cable-tie used to hold the mouthpiece in place. When using the necklace, simply squeeze the ends of the opening together to fit tightly around the mouthpiece.

OTG Scuba Diving Yoke First Stage Regulator Dust Cap is an idea to prevent sand, dust and water from entering your Yoke First Stage.

OTG Scuba Diving Female 9/16"-18 to Male 3/8"-24 Adapter is to allow divers to connect a LP first stage port to a LP second stage fitting. Essentially performing the same function as a standard LP regulator hose, but without the hose. This adapter is made by marine chrome plated brass and is 40% Nitrox ready. The working pressure is below 200psi and is for low pressure use only.