Tool

OTG Scuba Diving BCD Bladder Flange Tool is used to remove and install the bladder flanges on some older BC's. It works with some Dive Rite, OMS, Hollis bladder and OPV flanges.

OTG Scuba Diving Standard BCD Wash Hose is for diver to wash the inside of their Buoyancy Compensator to remove the build up of salt crystals and foreign deposits much more easier. This wash hose is fit for the inflator with standard male QD nipple. Just connect the BCD inflator QD nipple to the garden hose and fill about half way with fresh water to fully rinse inside. Then give the BC a good shaking. Invert the BC, drain the water and debris out by depressing the oral inflator button. Please make sure to inflate the BCD and allow to dry before storing. It is a much more easier way to clean up the BCD.

The OTG Scuba Diving Mini Size Compact Multi Tool features stainless steel tools within a very compact metal housing. This is a premium quality tool that includes eight of the most commonly needed Scuba repair tools, including a variety of hex keys, screwdrivers, a brass o-ring pick, and even a Schrader valve tool.

OTG Technical Scuba Diving Inline Second Stage Regulator Adjustment Tool is used for fine tuning 2nd stages regulator. The tool has a built-in pressure gauge which allows the intermediate pressure (IP) of the first stage to be checked and adjusted if necessary. Then connect the tool inline between the 2nd stage regulator and the LP hose, allowing adjustments while the hose is pressurized. The flat slot drive of the tool will be inserted in to the 2nd stage to allow the orifice to be turned to find exactly the proper adjustment for the 2nd stage air inlet. It's fit for most modern designs 2nd stage regulator which is adjust by flat slot drive.

OTG Scuba Diving 1/4" NPT Male to Standard BC Inflator Quick Connector Adapter are used by most compressed air powered tools. With this adapter, you can power all sorts of air tools by scuba tank using first stage regulator and BC inflator hose.

OTG Intermediate Pressure Gauge is for diver to diagnose problems of the 1st stage Regulator. It's often very helpful to know if the IP (Intermediate Pressure) is out-of-range. Just plugs the Gauge into any standard BC low pressure inflator hose, it is easy to use. Most of the modern scuba 1st stage regulator should have an intermediate pressure of about 130 to 142 psi.

OTG Technical Scuba Diving Din To Yoke Cylinder Filling Adapter is for 200 / 300 Bar Din valve to filling with a standard Yoke filler up to 3,000 psi (200 bars). Just bring this adapter with you wherever you go, you can fill your Din cylinder from any dive operator even they only can fill the Yoke valve cylinder.