Tool

OTG Technical Scuba Diving Inline Second Stage Regulator Adjustment Tool is used for fine tuning 2nd stage regulator. Just connect the tool inline between the 2nd stage regulator and the LP hose, allowing adjustment while the hose is pressurized. The flat slot drive of the tool will be inserted in to the 2nd stage to allow the orifice to be turned to find the exactly the proper adjustment for the 2nd stage air inlet. It is fit for most modern design 2nd stage regulator which is adjust by flat slot drive.

OTG Scuba Diving Seaquest BCD Wash Hose is for diver to wash the inside of their Buoyancy Compensator to remove the build up of salt crystals and foreign deposits much more easier. This wash hose is fits for the Seaquest inflator. Just connect the BCD inflator QD nipple to the garden hose and fill about half way with fresh water to fully rinse inside. Then give the BC a good shaking. Invert the BC, drain the water and debris out by depressing the oral inflator button. Please make sure to inflate the BCD and allow to dry before storing. It is a much more easier way to clean up the BCD.

OTG Scuba Diving Scubapro Air 2 BCD Wash Hose is for diver to wash the inside of their Buoyancy Compensator to remove the build up of salt crystals and foreign deposits much more easier. This wash hose is fits for the Scubapro Air 2 inflator. Just connect the BCD inflator QD nipple to the garden hose and fill about half way with fresh water to fully rinse inside. Then give the BC a good shakin. Invert the BC, drain the water and debris out by depressing the oral inflator button. Please make sure to inflate the BCD and allow to dry before storing. It is a much more easier way to clean up the BCD.

OTG Scuba Diving Adjustable Spanner Wrench is used for the removal and installation of the ambient pressure cap on first stages. Our Spanner Wrench is fit for most manufacturers’ first stage regulator and the Adjustable range is 0.75" to 2.0" circle diameter. It comes with three spanner pins and the size is (4.73mm / 0.185"), (3.97mm / 0.152") and (3.17mm / 0.122").

OTG Scuba Diving 3 piece Brass O-Ring Pick Set Tool - This three piece brass o-ring pick set is specifically designed for removal and placement of o-rings. The brass tips won't scratch soft seating surfaces in valves, regulators underwater camera / video case or other equipment. The color coded plastic handles have a comfortable ridged grip. Two of the tools have a sharp point and work well for removal, the third has a tiny ball on the end and is nice for placement.

OTG Scuba Diving BCD Bladder Flange Tool is used to remove and install the bladder flanges on some older BC's. It works with some Dive Rite, OMS, Hollis bladder and OPV flanges.

OTG Scuba Diving Standard BCD Wash Hose is for diver to wash the inside of their Buoyancy Compensator to remove the build up of salt crystals and foreign deposits much more easier. This wash hose is fit for the inflator with standard male QD nipple. Just connect the BCD inflator QD nipple to the garden hose and fill about half way with fresh water to fully rinse inside. Then give the BC a good shaking. Invert the BC, drain the water and debris out by depressing the oral inflator button. Please make sure to inflate the BCD and allow to dry before storing. It is a much more easier way to clean up the BCD.